MAIN STEPS
1. Update the firmware to version 205
2. Apply admin mode for the printer
3. Adjust "Auto Level Max Distance”
4. Disable the pressure sensor
5. Redo the manual level before printing
Step1: Update the firmware to version 205
AccuFab-D1 firmware update procedure - V2.0.1.205
Step2: Apply admin mode for the printer
AccuFab-D1 Admin Login on printer
Step3: Adjust "Auto Level Max Distance”
Go back to the main interface -> "Setting" -> "Admin Settings" -> "Auto Level Settings" ->
Change the "Auto Level Max Distance" same as "Manual Level Distance". In this example, change 4.0mm to 2.0mm.
Step4: Disable the pressure sensor
Step5: Redo the manual level before printing
AccuFab-D1 Manual Level - New Method