Preview Intraoral Scan Data


The new version adds 3D preview of intraoral scan data in the order creation interface. After importing the intraoral data, the upper and lower jaw models display both occlusal surfaces by default. Users can manipulate the model by clicking to rotate, using the sliding wheel for scaling, moving the cursor while holding down the left and right mouse buttons for translation, and finally clicking the Fit View button in the top right corner of the “Model Preview” to reset the model to its initial state. If there are multiple sets of models, users can select the pre-operative jaw, common jaw, or implant jaw from the drop-down list. The priority for displaying these models in the alignment interface is pre-operative > common > implant.



Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.